Open the computer’s Internet Explorer browser and type this URL into the Address bar:Ĭlick the forward arrow in the Address bar. Wait approximately two minutes for the SB2 to power on. Plug the modem AC power cord into the power outlet. Note: If the SB2 modem has a single IFL port, use this port. These steps assume that the 1.2M ODU is sitting on its mount, and that cabling and grounding are complete.įollow these steps to configure the SurfBeam 2 modem and TRIA prior to beginning the Point and Peak process.Ĭonnect the computer to the SB2 modem using the Ethernet cable between the LAN ports on both devicesĬonnect the COAX cable between the Transmit (TX) port on the TRIA, and the TX port on the SB2 modem. Recall that the TRIA receives its polarity setting from the SurfBeam 2 (SB2) modem, which in turn receives its satellite and beam assignments, and frequency set information from the Modem Key found on the work order. NOTE: To point and Peak with a Viasat Wireless Gateway or Modem see: Note: This may be either the customer’s computer or the installer’s laptop. A computer with a Ethernet port and Ethernet cable.To point and peak a 1.2M ODU using the SurfBeam 2 (SB2) modem, an installer needs these tools:
This Job Aid supports all Installer audiences. Point Azimuth Peak Azimuth Peak Elevation Push/Pull Test Configure the SurfBeam 2 Modem and TRIA Point Elevation
0 kommentar(er)
